Automotive Accessories

Jeep Builder Flips Rear Differential for Budget Rear-Only Portal Axle

Mei-Lin ChenNovember 17, 20265 min read0 views

At a glance

  • Zeph Gage's rear-only portal setup uses a flipped Ford 9-inch differential, Humvee geared hubs and custom brackets to add clearance at about one-fifth the cost of a typical portal-axle pair.
  • Zeph Gage built a rear-only portal axle for an XJ Jeep by flipping a Ford 9-inch differential and combining it with Humvee geared hubs and custom parts. The setup is intended to add about six inches of clearance while preserving shock travel, at roughly one-fifth the cost of a typical $20,000 portal-axle pair.
A generic off-road wagon is shown from a low rear angle with a raised rear axle, geared hubs and custom axle hardware on a rocky trail.

Portal axles are prized in hard-core off-roading because they raise a vehicle's drivetrain components and help it clear obstacles, but a typical set is expensive. A build by Zeph Gage takes a different route: it installs a portal axle only at the rear of an XJ Jeep and uses a flipped differential to keep costs down.

The central idea is to combine a Ford 9-inch axle housing with geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. A typical pair of portal axles from companies such as 74Weld costs about $20,000; the unit on Gage's Jeep costs one-fifth of that. The result is not an off-the-shelf kit. It relies on custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper.

How the rear-only portal works

Portal axles place a stack of gears behind each driven wheel instead of letting shafts and other components hang below the transmission and transfer case. That arrangement lets the axle shafts sit higher and leaves less hardware below the frame. Tall tires can then add further clearance. In a conventional two-gear portal like the Humvee's, the input shaft's rotation is reversed. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the correct direction. A Yukon Gear and Axle third member is bolted to the diff, creating what the build describes as a budget high-pinion unit from low-pinion parts turned upside down.

The conversion is intended to add about six inches of clearance. It also retains full shock travel, a difficult goal with portal axles, and is intended to reduce stress on the differential. The design is described as effectively bulletproof as a result, but that is a builder claim rather than an independent test result.

Why only the rear axle

Installing a portal only at the rear may look unusual, but it follows a practice used in remote-control rock crawling. Keeping the solid axle at the front avoids the packaging constraints that can arise when portal axles are added to a vehicle that did not have them from the factory. It also avoids restricting shock travel to fit the front conversion, and it keeps ride height from rising excessively. The rear end gains clearance without forcing the same compromises at the front.

The custom details extend to the brakes. Gage used a two-piece rotor with a Ford Fusion caliper, a choice that provides an integrated electric emergency-brake solenoid and helps with clearance. The build lists these as reasons for the selection. The completed XJ can drive over a five-gallon bucket and still have several inches of clearance to spare, a practical demonstration of the rear-end clearance gained.

With the solid front axle retained, the front end can steer around obstacles that might otherwise hang up the rear. The rear portal axle is meant to prevent the back of the vehicle from getting stuck on those obstacles. Matching the gearing front and rear was part of the build, and more specifics are covered in a video from Outdoor Auto.

Reported by Mei-Lin Chen, Interior and Exterior Accessories Fitment Analyst.